The history of Towel Weaving Loom

Towel Weaving Loom first appeared in England in the early 19th century. China began to produce automatic towel looms in the 1950s. The working width of the towel loom has a variety of specifications such as 105-230 cm. If you install the dobby, jacquard and multi-shuttle box device, you can weave a variety of towel fabrics. The warp let-off and beat-up mechanism of the towel loom is different from that of the ordinary loom. The let-off amount of the yarn let-off mechanism of the wool warp knitting shaft can be adjusted according to the required height of the pile. The let-off amount of the ground warp weaving shaft let-off mechanism remains constant. Under normal circumstances, the tension of the ground warp yarn is greater than that of the pile warp yarn, and the discharge length of the pile warp yarn is longer than the ground warp yarn. The reed in the beating-up mechanism is generally installed on the movable sley to complete the regular movement of the pile. When weaving three weft towels, the beating-up strokes of the first and second weft reeds are small, and when the third weft is weaving, the beating-up strokes of the reed become larger. At the same time, the first, second, and third wefts are pushed together to the weaving. At the opening, the weft will clamp the raised warp and slide along the ground warp with greater tension, so that the raised warp sent by the wool warp weaving shaft will form a loop on the surface of the fabric. When weaving the towel fabric on the gripper loom, there is no need to change the stroke of the reed, but a device for moving the weaving mouth is adopted to make the weaving mouth move back and forth according to a specific rule during the beating-up to form a towel fabric.Towel Weaving Loom is your good choice.